Garage door won't close: sensor repair in Rye Brook

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (914) 848-9128

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Rye Brook repairs the sensors and re-tests the opener's safety system.

Chain-drive garage door opener under exposed rafters

Doors that won't close in Rye Brook

Rye Brook is mostly residential and comparatively young. In BelleFair and Doral Greens, planned communities with attached garages close together, the sensors are newer, and the usual cause is simple: a stroller, a bin or a delivery box in the beam, or a bracket caught by a car door. Along the King Street corridor and near the Port Chester border, older houses have detached garages and wood frames. In the Blind Brook area, mid-century ranches and splits have original brackets that have been bent and re-bent. Low ground near the brook stays damp. Community rules often mean doors are kept closed, so a door that won't close gets noticed fast.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Rye Brook

  • Port Chester border: The village's oldest and densest streets, with smaller lots and older garages.
  • Blind Brook area: Residential streets near the brook and Crawford Park, where damp can be a factor.

See the full Rye Brook service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 848-9128
Call (914) 848-9128